Filter
Top Products
21
Section 1: Assembly and Set-Up
5/09/08
RCR2596, RCR2510 and RCRM2510 Rotary Cutters 312-753M
Land Pride
Table of Contents
2. Remove parking jack (#1) from cutter deck and
secure to cutter tongue by fully inserting locking pin
(#2) through the parking jack and mounting bracket
as shown.
3. Add stroke control spacers to the cylinder rod to
prevent the cylinder from retracting. See “Pull-Type
Cutter” on page 23.
4. Use parking jack (#1) to raise and lower cutter
tongue to thecorrect height todisconnect clevishitch
(#6) from the tractor drawbar.
5. Remove 1”-8 x 4 1/2” hex bolt (#3), flat washers (#5)
and locknut (#4) from the clevis hitch (#6).
6. Disconnect hydraulic hose (#9) from tractor. Store
hose end on cutter deck.
Check Chains, 3-Point Lift-Type Cutters
(Available through Land Pride parts department.)
Refer to Figure 1-18:
Check chains are used to control the cutting height and
allow the mower to be lowered to the same preset cutting
height effortlessly.
1. Install lower end of checkchain (#1) to the inner hitch
ear as shown in Figure 1-18, using the 3/4”-10 x 1 1/
2 long bolts (#2), lock washers (#3) and nuts (#4).
Tighten securely.
2. Install chain lugs (#5) on either side of the tractor top
link mount using pin (not supplied).
3. Cutting height is then set by placing proper chain link
in key slot (#5).
NOTE: For additional safety in transport, raise
cutter as high as possible, and shorten check chains
to prevent inadvertent falling in transport.
Check Chain Assembly
Figure 1-18
22314