Filter
Top Products
16
Section 1: Assembly and Set-Up
RCR2596, RCR2510 and RCRM2510 Rotary Cutters 312-753M
5/09/08
Land Pride
Table of Contents
Rubber Safety Shields (Optional)
!
DANGER!
Rotary Cutters have the ability to discharge objects at high
speeds; therefore, the use of front and rear safety shields is
strongly recommended when cutting along highways or in an
area where people may be present.
Front Rubber Shields (RCR2596)
Refer to Figure 1-11
Install front rubber shields (#1) with 1/2” -13 x 2 3/4” long
carriage bolts (#2) and flange nuts (#3) as shown.
Front Rubber Shields (RCR(M)2510
Refer to Figure 1-12
Install front rubber shields (#1) & (#2) with 1/2” -13 x 3 1/
2” long carriage bolts (#3) and flange nuts (#4) as shown.
Rear Rubber Shield
Refer to Figure 1-13
Install rear rubber shield (#1) and rear shield strap (#2)
with 1/2” -13 x 1 1/2” long carriage bolts (#3) and
1/2” flange nuts (#4) as shown.
NOTE: Do not tighten hardware until assemblies
are complete. Refer to “Torque Values Chart for
Common Bolt Sizes” on page 38.
RCR2596 Front Rubber Shields
Figure 1-11
RCR2510 & RCRM2510 Front Rubber Shields
Figure 1-12
Rear Rubber Shield
Figure 1-13
22307
22308
16266