Filter
Top Products
15
Section 1: Assembly and Set-Up
5/09/08
RCR2596, RCR2510 and RCRM2510 Rotary Cutters 312-753M
Land Pride
Table of Contents
Chain Safety Shields (Optional)
!
DANGER!
Rotary Cutters have the ability to discharge objects at high
speeds; therefore, the use of front and rear safety shields is
strongly recommended when cutting along highways or in an
area where people may be present.
Front Chain Shields (RCR2596)
Refer to Figure 1-8
Install each front chain shield (#1) with 1/2-13 x 2 3/4”
long carriage bolts (#2) and flange nuts (#3) as shown.
Front Chain Shields (RCR(M)2510)
Refer to Figure 1-9
Install front chain shields (#1) & (#2) with 1/2” -13 x 3 1/
2” long carriage bolts (#3) and flange nuts (#4) as shown.
Rear Chain Shield
Refer to Figure 1-10
Install rear chain shield (#1) with 1/2” -13 x 1 1/2” long
carriage bolts (#2) and 1/2” flange nuts (#3) as shown.
NOTE: Do not tighten hardware until assemblies
are complete. Refer to “Torque Values Chart for
Common Bolt Sizes” on page 38.
RCR2596 Front Chain Shield
Figure 1-8
RCR2510 & RCRM2510 Front Chain Shield
Figure 1-9
Rear Chain Shield
Figure 1-10
22292
22291
16258