Filter
Top Products
19
Section 1: Assembly and Set-Up
5/09/08
RCR2596, RCR2510 and RCRM2510 Rotary Cutters 312-753M
Land Pride
Table of Contents
5. With driveline profiles pulled apart, apply multi-
purpose grease to the inside of the outer profile and
reassemble the two profiles.
6. Attach inner driveline yoke to the gearbox shaft and
outer driveline yoke to the tractor PTO shaft.
7. The driveline should now be moved back and forth to
insure that both ends are secured. Reattach any end
that is loose.
8. Hook a safety chain in the hole on the outer driveline
yoke shield and its opposite end to the tractor.
9. Hook the other safety chain in the hole on the inner
driveline yoke shield and its opposite end to the
cutter.
10. Start tractor and raise Rotary Cutter just enough to
remove support blocks fro under the cutter deck.
11. Slowly engage tractor’s 3-point controls to lower the
cutter. Check for sufficient drawbar clearance. Move
drawbar ahead, aside or remove if required.
IMPORTANT: Two small chains are supplied with
the driveline. These chains must be attached to the
outer and inner driveline yoke shields and to the
cutter deck and tractor to keep the driveline shields
from rotating.