Filter
Top Products
72 – English
SERVICE JOURNAL
Delivery Service
1. Fill the battery with battery acid and charge for four hours.
2. Fit the steering wheel, seat and, where applicable, other components.
3. Attach the cutting unit.
4. Adjust the cutting unit:
Adjust the lifting springs (the ”weight” of the cutting unit should be
12-15 kg, if a brush is to be used, set to maximum spring power).
Adjust the cutting unit so that its rear edge is about 2-4 mm
higher than its front edge.
Adjust the cutting unit’s cutting height setting so that the cutting
height limit is 5 mm above the unit frame at the lowest cutting
height.
5. Check that the right amount of oil is in the engine and transmission.
6. Check and adjust the air pressure in the tyres (60 kPa, 0.6 bar).
7. Connect the battery.
8. Fill the fuel tank and start the engine.
9. Check that the machine does not move in neutral.
10. Check:
Driving forwards.
Reversing.
Engaging the blades.
Safety switch in the seat.
Safety switch for the lifting lever.
The safety switch for the hydrostat pedals.
11. Check the engine speed: 2,900 ±75 rpm.
12. Bleed the hydraulic system, top up with oil if necessary.
13. Check the mounting bolts on the muffler.
14. Inform the customer about:
The need and benefit of following the service schedule.
The need and advantages of leaving the machine for service
every 300 hours.
The effects of service and maintaining a service journal on the
machine’s resale value.
Application areas for BioClip.
15. Fill in the sales certificate, etc.
Delivery service has been carried
out.
No remaining notes.
Certified:
After the First 8 Hours
1. Change engine oil.
Action
Date, mileage reading, stamp,
signature