Filter
Top Products
50 – English
MAINTENANCE
8. Lift off the drive belt (1). Now pull out the split
pin (2).
9. Pull the frame forwards and refit the pin.
10. Grasp the cutting unit’s front edge, pull out and
lift up into the service position.
If the cylindrical bolt, which is now holding the
cutting unit is removed, the cutting unit can be
lifted off.
Releasing the Service Position
To leave the service position, reverse the
procedures set out in ”Placing in the Service
Position”. Make sure that the cutting unit’s tongue
(3) enters the loop correctly on the underside of the
machine.
WARNING!
Observe caution to avoid trapping
your hand.
2
1
6017-225
6017-226
6017-227
8009-595