Filter
Top Products
English – 59
7. Belt Tensioner
Lubricate using a grease gun, 1 nipple from the
right-hand side under the engine’s lower belt pulley,
until grease is forced out.
Use only good quality molybdenum disulphide
grease.
Grease from well-known brand names
(petrochemical companies, etc.) usually maintains
a good quality.
LUBRICATION
6008-232
8009-158
8009-159
8009-140
8. Engine Oil
Check the oil level in the engine when the Rider
stands horizontal with the engine switched off.
Open the engine cover.
Remove the dipstick and wipe it clean. Now insert
the dipstick again, without tightening it.
Take the dipstick out again and read the oil level.
The oil is topped up through the hole the dipstick
sits in.
Use engine oil SAE 30, SAE 10W/30 or 10W/40,
class SF-SJ (above 0 °C/+32 °F).
SAE 40 can be used above +20 °C/+68 °F.
Use engine oil SAE 5W/20, class SF-SJ
(below 0 °C/+32 °F).
Fill the oil slowly. Tighten the dipstick correctly
before starting the engine. Start and run the engine
at idling speed for approx. 30 seconds. Turn off the
engine. Wait 30 seconds and check oil level. If
necessary fill so that the oil comes up to the ”FULL”
mark on the dipstick.
The engine holds 1.5 litres of oil excluding the filter
and 1.7 litres including the filter.
The oil level should be between the markings on
the dipstick. If the level is approaching the ”ADD”
mark, top up the oil to the ”FULL” mark on the
dipstick.
Never fill above the ”FULL” mark.