Filter
Top Products
English – 61
LUBRICATION
10. Parking Brake Cable Pro 15, Pro 18
Remove the transmission cover, see ”Gear Lever”.
Unhook the spring (A) from the screw (B) if required
(not AWD).
Remove the cable’s rubber casing when lubricating.
Lubricate the cable with an oilcan, press the brake
pedal a few times and lubricate again.
Replace the spring (A) and the transmission cover.
11. Transmission Oil Level Pro 15, Pro 18
1. Check the oil level in the transmission by
looking through the air intake mesh. The oil
level shall be between the MIN and MAX
markings on the oil container when at +20 °C.
If the oil needs to be filled, you must first
remove the transmission cover.
2. Unscrew the oil container’s cover and fill with
SAE 10W/30 engine oil, class SF–CC, until the
oil level reaches the MAX mark. Then screw the
oil container’s cap into place and attach the
transmission cover.
The oil should be changed by an authorised service
workshop, and is described in the Workshop
Manual.
Filter replacement on Pro 18 is done at the same
time as changing the oil.
B
A
6008-210
6020-005
12. Hydraulic System and Transmission
Oil level Pro 18 AWD
1. Remove the transmission cover.
2. Check the level, it should be visible in the sight
glass at 20 °C when the machine stands flat.
3. Unscrew the oil container’s cover and fill with
SAE 10W/40 engine oil, class SF-CC, until the
oil level is visible in the top of the sight glass.
Then screw the oil container’s cap into place
and attach the transmission cover.
The oil should be changed by an authorised service
workshop, and is described in the Workshop
Manual.
The filter is replaced at the same time as changing
the oil.
Work on the system entails particular demands on
cleanliness and the system must be vented before
the machine is used.
8009-702