Filter
Top Products
English – 23
25
50 100 300
Lubricate the right, rear axle bearing
Pro 18 AWD 63 ●
Clean the engine’s cooling air intake 31 ●●
Clean the air filter’s pre-cleaner
(foamed plastic) 29+30 ●●
Change the engine oil
1)
60 ●●
1)
●
1)
Clean the air filter’s filter cartridge
2)
(paper filter) 29+30 ●●
Check/adjust the cutting height 45 ●●
Check/adjust the parking brake 26 ●●
Inspect the flame proofing/spark arrestor
(extra equipment) - ❍❍
Replace the engine oil filter (every 200 hours) 62 ●●
Replace the hydraulic oil filter (every 200 hours)
5)
62 ●●
Clean/replace the spark plugs 32 ●●
Change the inline fuel filter 28 ●●
Clean the pulse air filter 28 ●●
Clean the cooling fins 28 ●●
Check the play in the engine valves
4)
- ❍❍
Check the need of an oil change
4)
and filter
replacement
5)
in the gearbox/hydraulic system - ❍❍
(every 200
6)
/500 hours)
Replace the suction filter in the hydraulic tank
(every 200 hours)
6)
- ❍❍
Replace the air filter’s pre-cleaner
(foamed plastic)
2)
29+30 ●●
Replace the air filter (paper filter)
2)
(every 200 hours) 29+30 ●●
Perform the 300-hour service
4)
- ❍❍
1)
First change after 8 hours. When operating with a heavy load or at high ambient temperatures, replace
every 50 hours.
2)
Maintenance and replacement are required more often in dusty conditions.
3)
With daily
use, the Rider should be lubricated twice weekly.
4)
Performed by an authorised service workshop.
5)
Pro 18 only.
6)
Pro 18 AWD only. Replace first after 50 hours.
MAINTENANCE
● = Described in this operator’s manual.
❍ = Not described in this manual.
WARNING!
No service operations may be performed on the engine or cutting unit unless:
• The engine has been stopped.
• The ignition key has been removed.
• The ignition cables have been removed from the spark plugs.
• The parking brake is on.
• The cutting unit is disengaged.
Maintenance
interval hours
Daily main-
tenance
before after
Weekly
3)
main-
tenance
At least
once
a year
Maintenance
Page