Filter
Top Products
32
2000 Owner’s Manual
CONTROL PANEL RESET
This function is used to completely reset the clock and all other system
variables to the factory defaults. Please keep in mind that this resets all
maintenance messages (clean filters, change water, etc.) as if the spa is
being installed the day of the panel reset.
To reset the control system all of the following pads must be pushed
within 3 seconds:
1) Push the ICON (logo) pad
2) Push the ENTER pad
3) Push the PROGRAM pad
The top line of the LCD will read “RESET PROGRAMMING?”
The bottom line of the LCD will read “IF SO, PUSH ICON”
4) Push the ICON pad to reset the entire control system to factory
defaults or do not touch a pad for 10 seconds to exit.
SCROLLING MESSAGE CENTER MESSAGES
Because of the advanced programming features of your scrolling display,
your spa will prompt you when you need to perform routine mainte-
nance. For example:
RINSE FILTERS
Every other month, the top line of your LCD display will read, “RINSE
FILTERS” and the message “REMOVE FILTERS & RINSE WITH
HOSE... PUSH AND HOLD ICON PAD MORE THAN 3 SECONDS
TO RESET THIS MESSAGE” will scroll from right to left on the bot-
tom line of the display. To reset this message, push and hold the
Dimension One Spas ICON (logo) pad located at the right hand side of
the control for 3 seconds.
CLEAN FILTERS
E v e ry alternating month, the top line of your LCD display will re a d ,
“ D I RTY FILTER” and the message “REMOVE FILTERS & CLEAN IN
SOLUTION... PUSH AND HOLD ICON PAD MORE THAN 3 SEC-
ONDS TO RESET THIS MESSAGE” will scroll from right to left on the
bottom line of the display. To reset this message, push and hold the
Dimension One Spas ICON (logo) pad located at the right hand side of
the control for 3 seconds.