Filter
Top Products
21
2000 Owner’s Manual
When the desired number is displayed, push the LIGHT pad to accept
the selection and change the flashing number to the “minute” place
(12:1_). Adjust this number with the UP or DOWN pad in the same
manner as the hour number. When the desired number is displayed,
push the LIGHT pad to accept the selection and change the flashing
number to a flashing AM or PM indicator. Adjust the indicator with the
UP or DOWN pads. When the desired indicator is displayed, push the
PROGRAM pad to accept the selection and enter the Filter Cycle Start
Time programming mode.
NOTE: If you do not set the proper time, the system will default to
11:59 a.m. upon startup.
FILTER CYCLE START TIME
To adjust the filter cycle start time, push the UP or DOWN AND
LIGHT pads as done in the Clock Set programming mode to choose a
time. Once the desired time is displayed, push the PROGRAM pad to
accept the selection and move into the Filter Cycle Duration program-
ming mode.
NOTE: You will be later prompted to set the filter cycle duration and
the number of filter cycles. Be sure to keep this in mind when program-
ming your filter cycle start time. During the filter cycle, JETS 1 will
activate, the first 5 minutes at high speed and the remainder of the filter
cycle time at low speed.
FILTER CYCLE DURATION
To adjust the filter cycle duration, push the UP or DOWN pad to cycle
through the choices of 60, 90, 120, 150 or 180 minutes (the default is
60). Once the desired time is displayed, push the PROGRAM pad to
accept the selection and move into the Number of Filter Cycles pro-
gramming mode.
CAUTION: Long and/or numerous filter cycles could cause overheat-
ing of the spa - especially in hot climates.