Filter
Top Products
18
2000 Owner’s Manual
and turn the pump(s) on again. Turn the pump(s) on and off several
times until the jets function properly.
6) When the jets are in full operation, close the bleeder valve and push
the UP pad until the desired spa temperature is indicated on the dis-
play screen. (The maximum settable temperature is 104˚, OR5 or
OR6.)
NOTE: While setting the temperature the LCD display will read
out the temperature up to 104˚ F. When the temperature exceeds
104˚ F, the display will read in “over-range” figures. I.E. At 105˚ F
the temperature will read “OR5” and at 106˚ F the temperature will
read “OR6”. Water temperatures in excess of 104˚ F should be
used with extreme caution.
NOTE: On initial start-up, you can confirm that the heater is on by
looking to see that the heat LED indicator, located on the right side
of the upper control panel, is illuminated. The heater icon on the
LCD and the heat indicator LED on the display will blink when
there is a call for heat and will come on solid when the heater is
actually on. Once you have verified that the heater is functioning,
you can reinstall the ventilated equipment access panel.
7) Depending upon the size of your spa and the size of the circuit break-
er used, heating will occur at the rate of 3-10˚ F per hour.
8) After completing the above steps, it is necessary to ensure proper
water chemistry. See the Water Chemistry section in this manual,
for the easy steps to maintaining clean and safe water. The schedule
shown may require more frequent adjustment depending on the
bather load.
9) Place the thermal cover on the spa to conserve energy and to keep it
ready for use.