Filter
Top Products
28
2000 Owner’s Manual
LIQUID CRYSTAL DISPLAY:
The LCD continuously shows the operating status of the spa, as well as
the various monitoring functions, self-diagnostics, and programming
information.
PROGRAMMING THE SCROLLING MESSAGE CEN -
TER:
Your Scrolling Message Center is the most advanced in the industry and
can virtually walk you through customizing your spa to your exact needs.
To initiate the programming sequence at any time, push and hold the
PROGRAM pad for 3 seconds. If, within 10 seconds, you do not pro-
ceed with the spa programming, the spa will automatically exit the pro-
gramming sequence and revert to the pre-set factory default settings. To
exit the programming sequence at any time, push the ENTER pad or do
not press a pad for 10 seconds. Any programming changes made up to
that point will be saved.
SETTING THE TIME:
After holding the PROGRAM pad, the top line of the LCD will read
“SET TIME OF DAY” and the bottom line will read “PUSH UP OR
DOWN TO CHANGE - PUSH PROGRAM TO SELECT NEXT
FUNCTION - PUSH ENTER TO EXIT ”. Push the UP or DOWN
pads to engage the time setting mode. The time screen will appear with
“hours” (_ _.00) flashing on and off. Push the UP or DOWN pad to
increase or decrease the number until the desired hour appears. When
the desired number is displayed, push the LIGHT pad to accept the
selection and change the flashing number to the “ten minute” place
(12:_0). Adjust the number with the UP or DOWN pad in the same
manner as the hour number. When the desired indicator is displayed,
push the LIGHT pad to accept the selection and change the flashing
number to the “minute” place (12:1_). Adjust this number with the UP
or DOWN pad in the same manner as the hour number. When the
desired number is displayed, push the LIGHT pad to accept the selection
and change the flashing number to a flashing AM or PM indicator.
Adjust the indicator with the UP or DOWN pads. After reaching the
correct time, push the PROGRAM pad to set the time and exit the
time-setting mode. You will then be prompted to set the filter start time.