Filter
Top Products
20
2000 Owner’s Manual
TEMPERATURE PADS
Pushing the UP pad increases the temperature and pushing the DOWN
pad decreases the temperature. Push the respective pad one time for
each degree of temperature change, or push and hold the pad for rapid
adjustment. The existing spa water temperature will remain in the digi-
tal display window until a temperature pad is pushed. When the UP or
DOWN pad is pushed the digital readout will indicate the new tempera-
ture setting, with the SET POINT Icon on the right side of the display.
Once the new temperature is set, the current spa water temperature will
again be indicated. The spa will heat to the pre-set temperature auto-
matically.
LIGHT
Push the LIGHT control pad once to activate the brightest setting. A
second push will activate the medium setting and a third push will acti-
vate the dimmest setting. The light icon and LED on the display will
come on when the light is activated. Push the LIGHT control pad a
fourth time to turn off the light. The light will automatically turn off
after a factory pre-set period of time.
PROGRAMMING THE PROGRAMMABLE DIGITAL
CONTROL
To initiate the programming sequence at any time, push and hold the
PROGRAM pad for 3 seconds. If, within 10 seconds, you do not pro-
ceed with the spa programming, the spa will automatically exit the pro-
gramming sequence and revert to the pre-set factory default settings. To
exit the programming sequence at any time, do not press any pad for 10
seconds. Any programming changes made up to that point will be saved.
CLOCK SET
Push and hold the PROGRAM pad for 3 seconds to engage the time set-
ting mode. The time screen will appear with “hours” (_ _.00) flashing
on and off. Push the UP or DOWN pad to increase or decrease the
number until the desired hour appears. When the desired number is
displayed, push the LIGHT pad to accept the selection and change the
flashing number to the “ten minute” place (12:_0). Adjust the number
with the UP or DOWN pad in the same manner as the hour number.