Filter
Top Products
30
2000 Owner’s Manual
PUMP RUN TIME
After setting the number of filter cycles, the top line of the LCD will re a d
“SET PUMP RUN TIME”. Push the UP or DOWN pads to toggle
between 30, 45 and 60 minutes. This sets the length of time the pump
will run when a jets pad is pushed. For example, if you choose 45 minutes,
when you push a jets pad, the pump will run for 45 minutes before shut-
ting down automatically. When your desired pump run time appears on
the LCD push the PROGRAM pad to select it. The pre-set factory
default is 30 minutes.
TEMPERATURE UNITS
After setting the pump run time, the top line of the LCD will read “SET
TEMPERATURE UNITS”. Push the UP or DOWN pads to toggle from
˚F to ˚C. When your desired temperature unit appears in the LCD, push
the PROGRAM pad to select it. The pre-set factory default is
Fahrenheit.
VISION CARTRIDGE
After setting the temperature units, the top line of the LCD will read “SET
VISION CARTRIDGE”. Push the UP or DOWN pads to toggle between
“ Yes” and “No”. If you are currently using a Vision Cartridge select yes, if
not, select no. Selecting “yes” will prompt the control to notify you when
your cartridge needs replacement. When your desired selection appears in
the LCD, push the PROGRAM pad to select it. The pre-set factory default
is “No”.
LCD INVERT
The invert feature will flip the text on the LCD so it can be easily read fro m
both inside and outside the spa. To invert the text, simply push the
“ENTER” pad three times. To re t u r n the text to its original position, re p e a t
this process - push the “ENTER” pad three times.
CONTROL PANEL LOCK
To help prevent unauthorized use of the spa, the control panel may be
locked. When the control panel lock is engaged, all programmed or
default spa functions will operate normally but all control pads will not
operate. When the panel is locked, the LCD will display message “ALL
SPA FUNCTIONS LOCKED”.