Filter
Top Products
27
2000 Owner’s Manual
NOTE: Pushing either JETS control pad will disable any concurrent fil-
ter cycle.
LIGHT CONTROL:
Push the LIGHT control pad once to activate the brightest setting. A
second push will activate the medium setting and a third push will acti-
vate the dimmest setting. A message indicating the current light inten-
sity will scroll twice on the bottom left of the LCD (i.e. LIGHT HIGH,
LIGHT MEDIUM, LIGHT LOW) and an animated icon, with zero,
three or six dots around it indicating the light’s intensity will be dis-
played. Push the LIGHT control pad a fourth time to turn off the light.
The light will automatically turn off after a factory pre-set period of time.
TEMPERATURE CONTROL:
When the UP or DOWN control pad is pushed to change the set tem-
perature, the bottom left of the LCD will read “SET TEMP TO _ _ _˚
F”. When there is a call for heat, the heater icon and LED will turn on
when the heater engages. This is a normal function. The right side of
the LCD will read the current temperature and the bottom left will read
“HEATING TO _ _ _˚ F” until the spa reaches the set temperature.
If the water reaches 2˚ above the set temperature, the message “COOL-
ING TO _ _ _ - CIRC PUMP & O3 OFF” will be displayed in the bot-
tom left hand side of the display and a cooling cycle will start.
ENTER PAD:
This pad is used to exit any programming sequence at any time.
PROGRAM PAD:
This pad is used to initiate the time setting, filter programming, and
other programming features. For more information, see the next section,
“Programming the Scrolling Message Center”.
DIMENSION ONE SPAS ICON PAD (LOGO):
The ICON pad is used to view the time-of-day. It is also used to initiate
the panel lock features and functions as a reset.