C2674M-C (7/09) 55
5. To configure the motion area, do the following:
a. On the front panel or remote control, press the up/down arrow buttons to highlight the Area option. Using the mouse, click the
Area option. The Area property is highlighted and motion detection can now be observed in the view window.
b. On the front panel or remote control, press ENTER. Using the mouse, click anywhere in the view window. The selection cursor is
placed in the first pixel of the view window.
Figure 52. Selecting the View Window
c. To clear the entire view window, do one of the following:
• On the front panel, press the SHIFT button and then press the ZOOM button.
• On the remote control, press the ZOOM- button .
• Using the mouse, click Clear All.
6. You can use the front panel or remote control to define the motion view area cell-by-cell, or you can use the mouse to click and drag to
define an area.
• To select a view area for motion detection, do one of the following:
– On the front panel or remote control, press any of the arrow buttons to highlight a cell in the motion detection
area, and then press ENTER. The selected cell turns green. Repeat this process until you have defined the motion detection area.
– If using the mouse, left-click and drag (diagonally up) an area, and then release the button. The area is selected and the cells turn
green.
Figure 53. Define and Select a Motion View Area
