Filter
Top Products
3-5
Default settings
The instrument is reset to the factory default settings in the following cases:
(1) At power-up.
(2) Following execution of the RCL 999 command.
(3) Following execution of the
*
RST command.
The default settings are shown in Table 3-1 .
Table 3-1 Instrument default settings
Carrier frequency :
Step :
2.4 GHz
1 kHz
RF level
Step :
Status:
RF output :
−137 dBm
1 dB
ON
Enabled
Modulation mode Internal FM, modulation disabled
Modulations : FM1 : Deviation: 0 Hz, OFF
: Internal source, frequency: 1 kHz, sine
FM2 : Deviation: 0 Hz, OFF
: Internal source, frequency: 400 Hz, sine
ΦM1 : Deviation: 0 rad, OFF
: Internal source, frequency: 1 kHz, sine
ΦM2 : Deviation: 0 rad, OFF
: Internal source, frequency: 400 Hz, sine
AM1 : Deviation: 0%, OFF
: Internal source, frequency: 1 kHz, sine
AM2 : Deviation: 0%, OFF
: Internal source, frequency: 400 Hz, sine
Pulse : OFF
Modulation steps :
∆FM 1 kHz, ∆ΦM 0.1 rad, ∆AM 1%
Mod frequency steps : 10 Hz
Carrier sweep
Freq mode:
Mode :
Type:
Ext trigger :
Start :
Stop:
Step size:
Time:
Fixed
Single sweep
Linear
OFF
9 kHz
2.4 GHz
1 kHz
50 ms