Filter
Top Products
Telect, Inc. • USA +1.509.926.6000 • Mexico +1.52.33.3836.3700
Poland +1.48.713.239.100 • UK +1.44.1489.889500 • www.telect.com
Copyright © 2002 Telect, Inc., All Rights Reserved
Page 2-4
b. The front versus rear of the base are dimensionally alike and interchangeable. The top versus bottom are not.
c. Place square washer from the anchor kit over the studs.
d. If using a regular L-shaped concrete anchor
, use a suitable nut and tighten all four corner anchors evenly to 38 ft-lb for ½-
in. low-carbon steel studs and fasteners or 83 ft-lb for
3
/8-in. hardware.
If using a Telect anchor kit, tighten breakaway torque nut until it shears off plastic-encased holding nut. At shear point, the
holding nut will be properly torqued to 60 ft-lb.
e. Remove and save four bolts and washers at top of base.
5. Use the illustration on the right as a guide in designing a two-point lift
for moving and placing cabinet over anchors.
ALERT
ALERT! DO NOT STAND BENEATH THE CABINET DURING
LIFTING.
6. After moving cabinet into place over anchors, use the Allen-head-style
key to open the doors.
7. Fasten cabinet to base or vault adapter, as shown in the following illus-
tration.
If fastening to a base, use the hardware removed in Step 4d.
8. Torque ½ in., low-carbon steel nuts/bolts to 38 ft-lb.
Either Square Washer From
Anchor Kit or a 1/4-in. Stack of
1/2-in. Fender Washers
Remove 1/2 in. Bolts & Washer Before Setting Cabinet on Base
Base
Washer & Breakaway Nut
From Anchor Kit
Installing a Base Using Telect Model MDC-CBAK Anchor Kit