Filter
Top Products
6 www.seektech.com Ridge Tool Company Elyria, Ohio U.S.A
SeekTech SR-60
Introduction to the SR-60
Getting Started
Installing/Changing Batteries
To install batteries into the SR-60, turn the unit over
to access the battery compartment. Turn the knob on
the battery cover counter clockwise. Pull straight up
on the knob to remove the cover. Insert the batteries
as shown on the inside decal and make sure they
drop to full contact. Fit the cover into the case and
turn the knob clockwise while lightly pressing down to
close. The battery cover can be installed in either
orientation.
Figure 2: Battery Case
When the SR-60 is powered on, it takes a few
seconds to check the batteries. Until then the battery
level will show as “empty”.
CAUTION
Do not allow debris or moisture into battery
compartment. Debris or moisture may short
the battery contacts, leading to rapid discharge
of the batteries, which could result in
electrolyte leakage or risk of fire.
Folding Mast
To begin operation, unfold the antenna mast and lock
the folding joint into place. When locating is
complete, press the red release lever to fold the
antenna mast for storage.
IMPORTANT
Do not snap or whip the SR-60 mast to open or
close it. Open it and close it by hand only.
NOTE: Avoid dragging the lower antenna node on
the ground while locating with the SR-60. It may
cause signal noise which will interfere with
results, and may eventually damage the antenna
.
Figure 3: Folding Antenna Mast and Release Button
SR-60 Modes
The SR-60 operates in three distinct modes. They
are:
1. Active Line Trace Mode, used when a
chosen frequency can be put onto a long
conductor using a Line Transmitter, for
locating conductive pipes, lines, or cables.
2. Passive Trace Mode, used for tracing
electrical lines that are already carrying 60
Hz current (U.S.), 50 Hz current (Europe), or
radio frequencies.
3. Sonde Mode, used for locating Sondes in
pipes, conduits, or tunnels that are non-
conductive or cannot otherwise be traced.
Note that the two Tracing modes, Active and Passive,
are identical except for the frequencies used. No
transmitter is used in Passive Trace mode.
Display Elements
Beginning operators or experienced operators can
use the SR-60 with equal ease. While the SR-60
offers advanced features that make the most
complex locate easier, many of its features can be
turned off or hidden, making the SR-60 simple to use
in basic locating in uncomplicated situations.
The “basic features” of the SR-60 are on by default.
They can be customized easily to suit the user’s
requirements. The use of the various elements
displayed is covered in later sections of this manual.