Filter
Top Products
Ridge Tool Company Elyria, Ohio U.S.A www.seektech.com 33
SeekTech SR-60
Figure 57: Signal Focus Control
Note this means that when using a more narrow
Signal Focus Control setting, it is necessary to move
the receiver along the line more slowly. This is a
trade-off for the improved focus, and will avoid
missing data updates at the slower rate.
When it is selected on, the Signal Focus Control is
changed to narrower or wider settings using the Up
(narrower) and Down (wider) Keys.
Signal Focus Control is useful when you need to
focus in on a particular signal with detail.
Sound Muting Î99’
This option automatically mutes sound when
Measured Depth is greater than 99 feet (30m). If it is
unchecked, the sound will not mute automatically.
Tracing Line Response
The Tracing Line distortion response checkbox sets
the sensitivity of the Target Line’s distortion display to
low, medium, or high -- or disables it altogether. The
higher the setting, the more sensitive the “distortion
cloud” around the Tracing Line becomes.
If the distortion response is disabled, the Tracing Line
will become a single solid line, and the screen will
show a second, dashed, line called the Distortion
Line. (See page
35 for a description of using this
alternative display.)
Frequency Selection Control
Additional available frequencies on the Master
Frequency Menu can be added to the Main Menu list
of available frequencies by going to the Frequency
Selection Control sub-menu
and
selecting the desired mode. All frequencies available
in the SR-60 for that mode will be displayed.
Checked frequencies are already “Currently
Available” – that is, selected to appear in the Main Menu.
From there, they can be set to “Checked-Active” status
to make them available by use of the Frequency Key
.
Checking a frequency to add it to the Main Menu will set
the unit to operating in that frequency and place it in
Checked-Active status.
To select additional frequencies, highlight and select the
Frequency Selection Control
sub-menu. Highlight
the category of the desired frequency (
Figure 58). Press
the Select Key
.
Figure 58: Selecting a Frequency Category
Then use the Up and Down Keys to scroll through the
available frequencies. Highlight the desired frequency to
add it to the currently available list (
Figure 59).
Figure 59: Highlighting a Frequency to Activate
Checking a frequency (using the Select Key) will enable
it to be included in the “Currently Available” list of
frequencies on the Main Menu (
Figure 60). Once on the
Main Menu, it can be set to “Checked-Active” status, and
then be put into use using the Frequency Key .