Filter
Top Products
58
8 INITIAL SETTING
10.Selection of primary MEAS setting : [PRIM. MEAS KEY]
Select whether the primary distance measurement is
MEAS SHOT or MEAS CONT or TRACK SHOT or
TRACK CONT.
11.Selection of second MEAS setting : [SEC. MEAS KEY]
Select whether the second distance measurement is
TRACK CONT or TRACK SHOT or MEAS CONT or
MEAS SHOT.
12.Selection of Minimum angle display : [MIN UNIT ANG]
Select whether to set the minimum angle display mode
to “COARSE (5 seconds)” or “FINE (1 second)”.
13.Selection of Vertical angle style : [V. ANG. STYLE]
Select whether the 0 point for vertical angle is set to be
“Z.0”, “H.0” or “COMPAS”.
14.Selection for Automatic power-off function :
[AUTO OFF]
Select the time interval (10, 20, or 30 minutes) for
activating the automatic power-off function, or select NIL,
disabling the function.
● The automatic power-off function automatically turns the power supply off
after the specified period of time (in minutes) when no operation for distance
measurement or for key entry has been performed with the angle remaining
unchanged.
15.Selection for Distance measurement automatic power-
off function : [EDM OFF]
Select the time interval (3, 5, or 10 minutes) for activating
the distance measurement automatic power-off function,
or select NIL, disabling the function.
● The distance measurement automatic power-off function automatically power-
off distance measurement after the specified period of time when no key
operation has been performed with the measured value remaining unchanged
(over about 0.1 m) during measurement.
1. MEAS SHOT
2. MEAS CONT
3. TRACK SHOT
4. TRACK CONT
1. TRACK CONT
2. TRACK SHOT
3. MEAS CONT
4. MEAS SHOT
1. COARSE
2. FINE
1. Z. 0
2. H. 0
3. COMPAS
1. 10 MIN
2. 20 MIN
3. 30 MIN
4. NIL
1. 3 MIN
2. 5 MIN
3. 10 MIN
4. NIL
PENTAX R-300 (p53-64) 10/30/02 11:13 AM Page 58