Filter
Top Products
5-5 Displaying the % Slope of the Vertical Angle
Press [F5] [MODE] to enter mode B.
Press [F2] [ANG SET] to display the Angle
setting screen.
Press the [F5] [SELECT] to change the
screen to display the slope % of Vertical
angle.
Press [F4] [DISP] to display the slope value in
%.
● The 0% represents the horizontal 0, and +100% and -100% represent 45° up
and down slopes respectively.
● To return the screen from the slope (%) display to the 360° scale, also take
above same steps by entering mode B.
● If the slope (%) exceeds [+/-]1000%, “Out of grade range” is displayed,
indicating that the current vertical angle cannot be measured.
● When the telescope returns to a slope within slope [+/-] 1000%, the slope (%)
display returns automatically from the “Out of grade range” message to the
numeric value.
40
5 ANGLE MEASUREMENT
S. FUNC
ANG SET
HOLD CORR MODE
MODE B 15°CS0
H. angle 20"30'92°
H
. dst.
V. dst.
ANGLE SET
1.
ANGLE / %GRADE
: ANGLE
2.
H. ANGLE INPUT
: 092° 30' 20"
3.
R/L REVERSE
: RIGHT
SELECT
MODE A 15°CS0
H. angle 20"30'92°
H
. dst.
V. dst.
MEAS TARGET 0 SET DISP MODE
MEAS TARGET 0 SET DISP MODE
MODE A 15°CS0
H. angle 20"30'92°
%. grade
-1.84%
S. dst.
PENTAX R-300 (p20-52) 10/30/02 11:08 AM Page 40