Filter
Top Products
Press the [ENT] key to accept the Prism
Constant to -25 mm.
Pressing the [ENT] key returns the instrument
to mode A.
● To set the Reflector sheet constant to “0” select “0” for “Prism Constant” in
“Initial Setting 1”.
● To set the Prism constant to “0” or “- 30” select “0” or “- 30” for “Prism
Constant” in “Initial Setting 1”.
● When the “Reflector sheet Constant” has been set to “0” in Initial Setting 1
and “Prism Constant” has been set to “0” or “- 30", “”is displayed to the left
of “0” or “- 30” on the correction menu screen. When “”is on the screen, the
Constant cannot be changed (by entering a numeric key).
● Once set, the Reflector sheet Constant and Prism Constant remains on the
measurement screen as “S 0” or “P 0”.
● The factory initial of Reflector sheet Constant and Prism Constant are 0.
● Once set, each Constant remains in memory even after the power is turned
oft.
47
7 CORRECTION MODE
CORRECTION
1.
PRISM CONST
: -25mm
2.
SHEET CONST
0mm
3.TEMP 15°C
4.PRESS 1013hPa
5.ppm 0ppm
SELECT
MEAS TARGET 0 SET DISP MODE
MODE A 15°CS0
H. angle 20"30'92°
H. dst.
V. dst.
PENTAX R-300 (p20-52) 10/30/02 11:08 AM Page 47