Filter
Top Products
Make sure the printhead cable does not touch the ribbon roll.
10. Clean the new printhead with a cotton swab dipped in
isopropyl alcohol to remove any salt or oil left from handling.
11. Let the printhead dry and reload your supplies.
12. Close the printhead assembly and the cover. Turn on the
printer.
13. Press Feed to position the supply under the printhead.
Adjusting the Wide/Narrow Knobs
You may need to adjust the two wide/narrow knobs according to
the width of your supply. For supply that is more than two inches,
adjust the knobs to the wide setting. For supply that is two inches
or less, adjust the knobs to the narrow setting. For wide supplies,
push down and turn the wide/narrow knobs clockwise with a
screwdriver. For narrow supplies, turn the wide/narrow knobs
counter-clockwise with a screwdriver until it pops back up.
You must adjust both of the knobs to the same position.
The adjustment is shown in the wide position.
5-6 Care and Maintenance
Rev. A 10/98