Filter
Top Products
You may need to adjust the wide/narrow knobs depending on
the width of your supply. See Chapter 5, "Care and
Maintenance," for more information.
For Peel Mode:
In peel mode, the printer separates the backing paper from the
label. The next label is not printed until the completed one is
removed from the printer. Make sure the printer is configured for
on-demand mode and the correct supply type.
The minimum feed length is 1.5 inches for peel mode. Hold the
leading edge of peeled labels when printing on stock longer than
six inches. You must use non-perforated supplies for peel mode.
Follow the steps for loading supplies from the previous section.
Then, follow these steps after you close the printhead.
1. Remove the labels from the first 10 inches of the backing
paper.
2. Press down on the exit cover tabs to open the exit cover on
the front of the printer.
Exit Cover
2-6 Loading Supplies
Rev. A 10/98