Filter
Top Products
Troubleshooting and Diagnostics
Continuedon next page JS56696,00009F41918MAY111/3
Troubleshooting
Blade height is incorrect.
Symptom Problem Solution
Displayed blade height does not
match actual blade height.
Ditch or levee depth or height does
not match desired height/depth.
Offset C or D had an incorrect
measurement during ditch track
recording.
Offset C should be the exact height of
the receiver when implement is in the
fully raised position.
Offset D should be the height of the
blade when the implement is in the
fully raised position.
Offset C and D were measured with
the implement in the fully raised
position but ditch track was recorded
with implement skimming the ground.
Machine receiver was used to record
ditch track and machine receiver
height measurement is incorrect.
Measure all offsets as instructed in
Operator’s Manual.
Ensure that offsets are measured
according to how the machine is used.
for example if ditch track is recorded
with scraper blade skimming the
ground, set up offset measurements
to reflect that in offsets C = offset D.
Can correct error, for example, if blade
(cutting edge) is on the ground, but
Profile View shows it as 2 in. above
the ground, increase Implement GPS
Offsets C (vertical distance from
receiver to ground) by 2 in.
Cannot record Ditch Track.
Symptom Problem Solution
Ditch track not showing up on map.
GS3 does not let operator record
ditch track.
Operator has not selected correct
“client, farm, field”.
Operator has not selected correct
tracking mode.
Guidance lines on map have been
turned off.
Ensure correct “client, farm, and field
are selected.
Ensure that correct tracking mode
has been selected from the Guidance
page—from the Guidance settings tab
select ditch track or levee track mode.
Ensure that guidance lines are turned
on—from the maps page select map
settings and then check the guidance
lines checkbox.
GS3 shows Machine travel direction reversed.
Symptom Problem Solution
GS3 shows machine direction of
travel reversed.
SWP does not allow recording.
When in survey mode using
a pickup or ATV, GS3 shows
direction of vehicle travel to be
reversed.
Direction of travel has been changed
on the Guidance page.
Some applications require mounting
the StarFire Receiver backward.
Under the StarFire softkey choose
to change the mount direction of the
receiver to match actual receiver
direction on machine.
Under the Guidance page select View
tab. On the View page select direction
of travel, change to match actual
travel direction.
503
061611
PN=52