John Deere OMPFP11362 Lawn Mower User Manual


  Open as PDF
of 60
 
Machine and Implement Setup
JS56696,00009D3 1901JUN113/3
JS56696,00009D4 1911MAY111/1
NOTE: Machine Turn Radius and Turning Sensitivity
are for use with iTEC Pro only.
Machine Turn Radius—How sharp the machine can
turn without an implement attached and without applying
brake pressure. The turn radius is half the diameter as
measured at the center of the rear axle of a row crop
tractor, and the pivot point on tracks and 4WD tractors.
Example: 8030 wheel tractors have a minimum turn
radius of 6.1—6.7 m (20—22 ft). Choose a number to
start with and change as needed for accuracy.
Turning Sensitivity—AutoTrac gain setting when the
vehicle is in an automated turn. This is adjustable by the
operator to improve performance (default 70).
Verify proper dimensions correspond to the Machine
selected.
NOTE: Not all recording sources are available
for all machines.
R—Machine Turn Radius
PC9890—UN—05FEB07
Machine Turn Radius
Machine Offsets
Select CHANGE OFFSETS button on Machine Setup
screen.
Offsets are used to eliminate skips or overlaps due to an
offset receiver.
To enter machine offsets:
•
Select input box.
•
Enter amount of offset in cm (in.) using numeric keypad
and select enter button.
•
Select the receiver toggle button to move the offset to
the right or left of cab center.
If no receiver offset is required, RECEIVER OFFSET input
box should read 0.
Machine offsets:
•
A) Lateral Distance from centerline of machine to GPS
receiver.
•
B) Inline distance from nonsteering axle to GPS
Receiver.
•
C) Inline distance from nonsteering axle to connection
point. The connection point is where the tractor
connects to the implement (drawbar, hitch) except
on 2 pt pivoting implements (large planter). In this
case, measure the distance back to the pivot point
immediately behind the hitch.
•
(D) Vertical distance from GPS receiver to the ground.
NOTE: Offset (D) is for use with Surface Water Pro.
PC13269—UN—28APR11
Machine Offsets
A—Lateral distance from
centerline of machine to
GPS receiver
B—Inline distance from
nonsteering axle to GPS
receiver
C—Inline distance from
nonsteering axle to
connection point
D—Vertical distance from GPS
receiver to the ground
E—Offset Toggle button
F—NonSteering Axle Location
dropdown menu
155
061611
PN=13
 previous next