Filter
Top Products
Machine and Implement Setup
JS56696,00009D5 1918MAY112/2
Select Change Offsets button (G).
NOTE: All items and changes will be saved under
the current implement name. Implement name
is also the base for transferring data to the
desktop software (if supported).
Verify implement setup before operating Surface
Water Pro Plus. Be sure hydraulic hookups are
in the proper locations and no other changes
to the implement have been made that could
cause unexpected behavior or a change in
vertical receiver position.
When using Surface Water Pro Plus for the
first time, it is necessary to define a name for
the implement being used. All dimensions
and parameters including GPS offsets on the
implement is stored to this name.
For implement setup, the following tabs are required to
be populated:
•
Implement Type
•
Implement Model
•
Implement Name—information is stored in relation to
this name
Verify or Enter implement: Type, Model, and Name in
dropdown boxes.
Implement name allows operator to save implement
dimensions.
NOTE: Select the correct name before changing
any offset dimensions.
Implement Type is required to be selected. Implement
Names are filtered by the type when Implement Model is
selected. For example, scraper or rotary ditcher.
Select CHANGE OFFSET button (G) and proceed to
following Implement Offsets section.
PC13799—UN—02JUN11
Implement Tab
A—Machine tab
B—Implement 1 tab
C—Implement 2 tab
D—Implement Type dropdown
menu
E—Implement Model
dropdown menu
F—Implement Name
dropdown menu
G—Change Offsets button
H—GPS Offsets button
I— Change Widths button
CHANGE WIDTHS button (I)—IMPLEMENT WIDTHS
are used to calculate CUT VOLUME on the EDIT DRAIN
screen. For example, Implement Width is entered as the
cutting blade width for the scraper.
157
061611
PN=15