Filter
Top Products
Instrument Panel - Elect. Cont. Later Engines
OURGP11,0000073 –19–04AUG06–3/3
How To Select Preset Operating Speeds (Bump
Speeds)
First select Turtle (Slow) or Adj by pressing speed
select switch (J) to “Turtle” (slow) or “Adj”(center).
Then you can press either the upper or lower portion
of the bump speed enable switch (H) to unlock the
setting. The bump speed enable must be held down as
the speed select switch (J) is used to change the
setting by pressing (+) to increase speed or (-) to
decrease speed.
Once the slow idle speed has been set, the bump
speed enable switch must be pressed and released
three times within two seconds to commit the new
operating speed to memory. If not done, the engine’s
new speed will only be effective until the key switch is
shut off. Then the speed will revert back to the
previous setting.
The fast idle speed is not adjustable. It will always go
back to the factory preset fast idle speed.
K—Analog Throttle Control (Optional)
The throttle control (K) is used to control engine
speed. This control is available only on engines with
analog throttle.
L—Engine Oil Pressure Gauge
The oil pressure gauge (L) indicates engine oil
pressure. An audible alarm (D) warns the operator if
engine oil pressure falls below a safe operating
pressure.
M—Engine Coolant Temperature Gauge
The engine coolant temperature gauge (M) indicates
engine coolant temperature. An audible alarm (D)
warns the operator if coolant temperature rises above
the preset safe operating temperature.
N—Menu Key
The menu key is pressed to either enter or exit the
menu screens on the diagnostic gauge.
O—Arrow Keys
Use the arrow keys (O) to change the display on the
window of the diagnostic gauge and to access engine
performance data.
Pressing the left arrow to scroll to the left or upward or
the right arrow to scroll to the right or downward. This
will allow you to view various engine parameters and
any diagnostic trouble codes that occur.
Refer to the following story for accessing engine
information on the diagnostic gauge using the touch
keys.
P—Enter Key
The enter key is pressed to select the parameter that
is highlighted on the screen.
Q—Amber “WARNING” Indicator Light
When light comes on, an abnormal condition exists. It
is not necessary to shutdown engine immediately, but
problem should be corrected as soon as possible.
R—Red “STOP ENGINE” Indicator Light
When light comes on, stop engine immediately or as
soon as safely possible to prevent engine damage.
Correct problem before restarting.
17-3
080706
PN=66