Filter
Top Products
64 - English
9. TROUBLESHOOTING
9.2 Indicator lamp in the charging station
For a fully functional installation, the indicator lamp in the charging station must emit a solid green light.
If something else appears, follow the troubleshooting guide below.
There is more troubleshooting help on www.automower.com. If you still need help with troubleshooting,
please contact the local dealer.
Light Cause Action
Solid green light Everything in order No action required
Blue flashing light The boundary wire is not connected
to the charging station
Check that the boundary wire
connector is fitted properly to the
charging station. See 3.5 Connecting
the boundary wire on page 28.
Break in the boundary wire. Find out where the break is. Replace
the damaged section of the boundary
wire with a new loop wire and splice
using an original coupler.
Yellow flashing light The guide wire is not connected to
the charging station
Check that the guide wire connector
is properly connected to the charging
station. See 3.6 Installation of the
guide wire on page 29.
Break in the guide wire Find out where the break is. Replace
the damaged section of the guide
wire with a new loop wire and splice
using an original coupler.
Red flashing light Interruption in the charging station's
antenna
Contact the local dealer.
Solid blue light Weak signal as the boundary wire is
too long. Max length is 250 metres.
No steps have to be taken if the
mower operates as expected.
Shorten the boundary wire by
reducing the working area or
replacing islands with barriers the
mower can collide with.
Weak signal due to damaged
boundary wire
Since it is difficult to locate where the
wire is damaged it is recommended
to lay a new boundary wire for the
entire working area.
Solid red light Defective circuit board in the charging
station
Contact the local dealer.