Filter
Top Products
20 - English
3. INSTALLATION
It is possible to let the low voltage cable cross the
working area. The low voltage cable must be stapled
down or buried, and the cutting height should be such
that the blades on the blade disc can never come in
contact with the low voltage cable.
Make sure the low voltage cable is laid along the
ground and secured with pegs 30” (75 cm) apart. The
cable must lie close to the ground so as not to be cut
before the grass roots have grown over it.
The transformer must be placed where it is well
ventilated and is not exposed to direct sunlight. The
transformer must be placed under a roof.
It is recommended to use an earth fault-breaker when
connecting the transformer to the wall socket.
The transformer must be mounted on a vertical
surface, such as a wall or a fence. Screw the
transformer in place using the two mounting eyelets.
No screws are supplied. Select screws suitable for
the material in question.
Do not, under any circumstances, mount the
transformer at a height where there is a risk it can be
submerged in water (at least 12” [30 cm] from the
ground). It is not permitted to place the transformer
on the ground.
IMPORTANT INFORMATION
The low voltage cable must not under any
circumstances be shortened or extended.
IMPORTANT INFORMATION
Place the low voltage cable so that the blades
on the blade disc can never come in contact
with it.
IMPORTANT INFORMATION
Use the plug to disconnect the charging
station, for instance before cleaning or
repairing the loop wire.
min 30cm/12”