Filter
Top Products
30 - English
3. INSTALLATION
Laying and connecting the guide wire
1. Run the wire through the slot in the bottom of the
charger plate.
2. Fit the connector to the guide wire in the same
way as for the boundary wire described in
3.5 Connecting the boundary wire. Connect it to
the contact pin on the charging station that is
labelled 'Guide'.
3. Run the wire at least 7 ft (2 m) straight out from
the front edge of the plate.
If the guide wire must be laid in a passage:
- The robotic lawnmower follows the guide wire
on the same side of the wire to and from the
charging station. This means that the robotic
lawnmower always runs on the left hand side of
the guide wire, as seen facing the charging
station.