Filter
Top Products
English - 49
6. MENU FUNCTIONS
Test IN
The Test IN function allows you to test how well the
robotic lawnmower docks with the charging station.
Test IN can only be performed after Test OUT has
been performed.
Selecting this function causes the mower to travel
directly along the guide wire towards the charging
station and docks with it. The test is approved only if
the mower is able to dock with the charging station at
the first attempt. If the mower is unable to dock on the
first attempt, it will automatically try again. The
installation is not approved if the mower needs two or
more attempts to dock with the charging station.
Drive past wire
The front of the mower always passes the boundary
wire by a specific distance before the mower turns.
The default distance is 10” (25 cm), but this can be
changed if required. The minimum value is 10”
(25 cm) and the maximum value is 12” (30 cm).
Now specify the number of centimetres you want the
mower to pass the boundary wire and press OK.
6.5 Security
Through this selection, settings relating to security
and the connection between the mower and the
charging station can be made.
Change PIN code
Enter the new PIN code and press OK. Enter the
same code again and confirm by pressing OK. When
the PIN code is changed, a message stating that the
PIN code has been changed appears in the display
momentarily.
Make a note of the new PIN code on the designated
line in Memo on page 4.
Security level
There are three security levels to choose from: low,
medium and high Low and medium security prohibits
access to the robotic lawnmower if the PIN code is
unknown. High security also includes a warning that
beeps if the correct PIN code is not entered after a
designated time period.
Guide width
Remote start 1
Remote start 2
Test settings
Drive past wire
Change PIN code
Security level
New loop signal
Timer
Installation
Security
Settings
Change PIN code
Security level
New loop signal
Low
Medium
High