Filter
Top Products
English - 33
3. INSTALLATION
3.8 First start-up and calibration
Before the robotic lawnmower is operated, a start-up
sequence in the robotic lawnmower's menu must be
carried out as well as an automatic calibration of the
guide signal. The calibration is also a good test to see
that the installation of the guide wire has been done in
such a way that the robotic lawnmower can easily
follow the guide wire from the charging station.
1. Set the main switch to position 1.
2. Open the control panel cover by pressing the
STOP button.
A start-up sequence begins when the robotic
lawnmower is started for the first time. The
following is requested:
• Language
• Time format
• Current time
• Date format
• Date
• Four digit PIN code. All combinations except
0000 are permitted.
3. Place the robotic lawnmower in the charging
station as requested in the display. The robotic
lawnmower will now start the guide calibration, by
leaving the charging station and following the
guide wire to the point where the guide wire is
connected to the boundary loop to begin mowing
there. Check that the robotic lawnmower can
follow the guide wire all the way.
If it cannot, this may be due to an incorrectly
installed guide wire. In this case, check that the
installation is performed as described in
3.6 Installation of the guide wire on page 29.
Therefore, carry out a new Test OUT, see
6.4 Installation on page 45.
IMPORTANT INFORMATION
Use MEMO on page 4 to make a note of the
PIN code.