Cal Spas LTR20051000 Hot Tub User Manual


 
Appendix
9800 Configuration Settings
WARNING! SHOCK HAZARD!
There are no user serviceable parts. DO NOT attempt service of this control system. Contact your dealer or
service center for service.
DIP Switches and Jumpers
Note: Switchbank B is totally disabled.
A1 Test mode OFF A7 N/A
A2 Add 1 pump with heat A8 N/A
A3 Add 2 pumps with heat A9 N/A
A4 N/A A10 No edit
A5 N/A A11 N/A
A6 N/A A12 Memory ON
A1 Test mode OFF A7 N/A
A2 Add 1 pump with heat A8 N/A
A3 Add 2 pumps with heat A9 N/A
A4 Add 3 pumps with heat A10 No edit
A5 N/A A11 N/A
A6 N/A A12 Memory ON
A1 Test mode OFF A7 N/A
A2 Add 1 pump with heat A8 N/A
A3 Add 2 pumps with heat A9 N/A
A4 N/A A10 No edit
A5 N/A A11 N/A
A6 N/A A12 Memory ON
DIP Switch Key
A1 Test mode (normally off)
A2 In ON mode, add one high-speed pump (or blower) with heater
A3 In ON mode, add two high-speed pumps (or one high speed pump and blower) with heater
A4 In ON mode, add four high-speed pumps (or three high speed pumps and blower) with heater
A5—A9 N/A
A10 When switched on when spa is on, system will enter the Edit Menu for configuration settings. Do
not start the spa with A10 turned on or a CFE error will occur. (CFE errors are illegal configurations
such as a pump and blower set to run on the same output. The configuration must be corrected
before the spa will operate.
A11 N/A
A12 Persistent memory reset (used when spaq is powering up)
Note: A2, A3, and A4 work in combination. Example: A2 and A3 in the ON position and A4 in the OFF
position will allow 3 high speed pumps (or two high speed pumps and the blower) to run with the heater.
2005 Spa Owner's Manual Page 69
8/1/2005