Filter
Top Products
Operating Your Spa
5200 Electronic Control Operation
Figure 7. 5200 Electronic Control
Initial Start up
When first powered up, the 5200 system (Figure 7) performs a self-diagnostic check, runs at high speed for two
seconds, and then switches to low speed to heat to and maintain 100°F until you change the set temperature as
described below.
Temperature Adjustment
Range 80°F to 104°F
The electronic control panel displays the actual water temperature in Fahrenheit.
To display the temperature that the spa is set to:
• Press the TEMP button. The set temperature setting will flash.
• While the display is flashing, each time you press the TEMP button, the set temperature will increase or
decrease by one degree.
Letting the display revert back to the actual water temperature, then pressing the TEMP button again will allow
you to change the direction of temperature adjustment.
Standard and Economy Modes
Your new spa is equipped with a heating feature that gives you complete control of the heating system. When
the spa is powered up, it will automatically start in the standard heating mode. In this mode, the heating system
will automatically activate whenever the water temperature drops more than one degree below the set
temperature. In the economy heating mode, the heating system will only activate during filtration times. (See
“
Setting Filtration Cycles”)
To switch from the standard heating mode to the economy heating mode, simply press the TEMP button
followed by the LIGHT button. Press the same sequence to switch back to the standard heating mode. Once in
the economy heating mode, Ec will display in the center of the control panel and flash alternately with the
water temperature.
Page 22 2005 Spa Owner's Manual
8/1/2005