Cal Spas LTR20051000 Hot Tub User Manual


 
Operating Your Spa
Page 40 2005 Spa Owner's Manual
8/1/2005
mode. Once the user finds the perfect massage mode, pressing either the UP or DOWN button will stop the
demo in that massage mode.
Time Reset Mode
Pulse mode will normally run for 15 minutes then automatically shut off. For another 15 minute session, press
the PUMP ON/OFF button and the PULSE MODE button. A green LED will blink and the pump will run on
high speed mode as part of a 15-minute cool down period. After that, the pump will stop automatically and the
green LED light on the panel will continue to blink for one minute then shut off automatically. After the second
fifteen minute session, the system will run through a cool down cycle for up to two hours. In this cool down
mode, the user will only be able to operate the pump (by again pressing the PUMP ON/OFF button). However,
the massage mode will remain off until the cool down mode is completed.
Pulse Mode System
Pulse mode system will shut off for two hours unless reset by the following procedure. During this time the
pump will run at a maximum speed.
In the off position, press the PULSE MODE button once.
The green power light will flash to indicate reset.
Multi-Colored Spa Light Operation
10 Dramatic Lighting Modes
Experience each different lighting mode by turning the spa light off and on to change lighting effects:
WHITE: Pure, bright white
SPECTRUM SLOW DANCE: Vibrant, slow fade through all colors
SUNBURST: Yellow and orange color swirl
BLUE: Clear and brilliant blue
RED: Radiant and invigorating red
GREEN: Nature’s lush green
MAGENTA: Rejuvenating glow of pink, blue and red
TIDAL FADE: Fade through blues and greens
AFTERBURNER FADE: Fade through red, orange, pink, yellow & purple
COLOR BURST: Energetic strobe through all colors
Operating the Multi-Colored Spa Light
1. Turn the spa light on by pressing the LIGHT button on the top-side control panel.
2. To filter through the different color choices, press the button on and off. Each time you press the button, you
advance to the next color.
3. To turn the spa light off when not in use, press the LIGHT button.