Filter
Top Products
Operating Your Spa
Page 32 2005 Spa Owner's Manual
8/1/2005
Time
When time hasn’t been programmed, the TIME icon flashes. To set the time, press the TIME button and then
the MODE/PROG button. Use the UP and DOWN buttons to adjust time. See the next page for more detailed
instructions.
Standard, Economy, Sleep, and Standby Modes
Mode/Prog: This button is used to switch between standard, economy, and sleep modes.
1. Press MODE/PROG to enter mode programming.
2. Press the DOWN button to cycle through to the desired mode.
3. Press MODE/PROG to confirm selection.
Standard Mode: This is programmed to maintain the desired temperature. Note that the last measured spa
temperature displayed is current only when the pump has been running for at least two minutes. The “STAND”
icon will display until the mode is changed.
Economy Mode: Economy mode heats the spa to the set temperature only during filter cycles. The “ECON”
icon will display until the mode is changed. Pressing the JETS 1 button while in economy mode puts the spa in
standard-in-economy mode, which operates the same as standard mode but reverts back to economy mode
automatically after one hour. During this time, pressing the MODE/PROG button will revert to economy mode
immediately.
Sleep Mode: Sleep mode heats the spa to within 20°F of the set temperature only during filter cycles. The
“SLEEP” icon will display until the mode is changed.
Standby Mode: Pressing “Warm” or “Cool” then “Jets 2” will turn off all spa functions temporarily. This is
helpful when changing a filter. Pressing any button resets the spa.
Jets 1 and Jets 2
Press the JETS 1 button once to turn pump 1 on or off and to shift between low and high speeds if equipped. If
left running, the low speed turns off after two hours and the high speed turns off after 15 minutes. On non-
circulation systems, the low speed of pump 1 runs when the blower or any other pump is on. It may also
activate for at least two minutes every 30 minutes to detect the spa temperature and then to heat to the set
temperature if needed, depending upon the mode. When the low speed turns on automatically, it cannot be
deactivated from the panel; however, the high speed may be started.
Option
This is an optional feature. Press the OPTION button to turn the optional equipment on and off. If left on, the
equipment will automatically turn off after 15 minutes.
Light
Press the LIGHT button to turn the spa light on and off and to shift between dim and bright settings if your light
is dimmable. On dim, the control panel will show the center circle plus one quarter of the light beams. Half of
the light beams will show on medium brightness, and all of the light beams will show on bright.
Invert
Press the INVERT button to change the numbers in the display to read upside down. Another press returns the
display to the right-side-up position. This enables you to read the display while you are in the spa.