Filter
Top Products
OUTLET MANAGED PDU
70
• HTTPS Port: Selects the TCP/IP port number that will be used for HTTPS
connections. (Default = 443.)
Notes:
• In the Text Interface, HTTP and HTTPS parameters reside in a
separate submenu. To enable and configure HTTP and HTTPS
Access via the Text Interface, access the Network Configuration
Menu as described in Section 5.9, then type 23, press [Enter] and
use the resulting submenu to select parameters.
• When the Web Access parameter is accessed via the Text
Interface, the resulting submenu will also allow you to select SSL
(encryption) parameters as described in Section 14.
• Harden Web Security: When the Harden Web Security feature is On
(default,) only the high and medium cypher suites for SSLv3 and TLSv1 will be
enabled. When the Harden Web Security feature is Off, all SSL protocols will
be enabled, allowing compatibility with older browsers. Note that in the Text
Interface, the Harden Web Security option is found in the Web Access submenu.
(Default = On.)
• SYSLOG Address: The IP Address or domain name (up to 64 characters)
for the Syslog Daemon that will receive log records generated by the Outlet
Managed PDU. For more information, please refer to Section 11.
(Default = undened.)
• Ping Access: Enables/Disables response to the ping command. When
Disabled, the Outlet Managed PDU will not respond to Ping commands. Note
that disabling Ping Access at the Network Port will not effect the Ping-No-
Access Alarm. (Default = On.)
5.9.3. IP Security
The IP Security feature allows the Outlet Managed PDU to restrict unauthorized
IP addresses from establishing inbound connections to the unit via telnet or Web
Browser. This allows you to grant access to only a specic group of Telnet or Web
IP addresses, or block a particular IP address completely. In the default state, the
Outlet Managed PDU accepts incoming IP connections from all hosts.
In the Text Interface, IP Security parameters are dened via the Network
Conguration menu. In the Web Browser Interface, these parameters are found by
placing the cursor over the "Network Conguration" link, and then clicking on the
"IP Security" link in the resulting y-out menu. In the default state, IP Security is
disabled. The IP Security Function employs a TCP Wrapper program which allows
the use of standard, Linux operators, wild cards and net/mask pairs to create a host
based access control list.