Black Box MPSH16-D20-120V Multi-tool User Manual


 
CHAPTER 2: Quick Start Guide
15
2. Quick Start Guide
This Quick Start Guide describes a simplied installation procedure for the Outlet
Managed PDU hardware, which will allow you to communicate with the unit in
order to demonstrate basic features and check for proper operation.
Note that this Quick Start Guide does not provide a detailed description of unit
conguration, or discuss advanced operating features in detail. In order to take full
advantage of the features provided by this unit, it is recommended to refer to the
remainder of this User’s Guide.
2.1. Installing the Outlet Managed PDU Hardware
2.1.1. Apply Power to the Outlet Managed PDU
Refer to power rating nameplate on the Outlet Managed PDU, and then connect the
unit to an appropriate power source. Note that some Outlet Managed PDU models
feature two separate AC inputs and two separate power branches, while others
feature a single power inlet. Connect power cable(s) to the unit’s Circuit "A" and
Circuit "B" Power Inlets (if present), install the cable keeper(s) (as described in
Section 4.1.1), then connect the cables to an appropriate power supply. Refer to the
table in the Specications section for information concerning power requirements
and maximum load.
Note:
To determine the exact model number for your Outlet Managed
PDU, either refer to the nameplate on the back of the unit, or access
command mode and then type /J * and press [Enter].