Filter
Top Products
© 2004 Alamo Group Inc.
Page 1 - 2
Interstater (NH TS-100A , 115A , 125A & 135A Asy. Manual) 06/04
PRE-DEL INSPECTION CHECKLIST
Pre-Operation Inspection: Check the following items before operating the unit to
assure that they are properly assembled. (See following page 1-4 for component location)
Saftey Equipment:
___ Operators Manual is with Unit.
___ The Safety Decals are installed as listed in the Assembly Manual.
___ Valve operation plate is installed.
___ Operators cage or Tractor Cab is in place
___ Deflectors are installed on the Mower Head
___ Tractor Rops or Cab with seatbels installed properly.
___ All Foot Guards and safety switch are installed and functional.
Frame:
___ Axle Plate Bolts are torqued.
___ Head Mounting Bolts tightened.
___ Frame attaching Bolts tightened.
___ Front Support Bolts are torqued.
___ Hydraulic Tank mounting Pins / Bolts in place correctly.
___ All Welds inspected toinsure proper welds and locations.
Hydraulic System:
___ Oil Level in Hydraulic Tank is within the sight gauge. (Item 5 page 1-4)
___ Hose connections are tight.
___ Hoses do not have any kinks or twist in them.
___ Front Pump Shaft adapter bolts are tight.
___ Front Pump Shaft Coupler / Drive Shaft is lubricated and has an anti-seize compound
on the Splines of Pump and Shafts.
___ The Pump Drive Shaft has correct alignment.
___ Suction Hose has no leaks or kinks.
Flail Mower Head:
___ Skid Shoe Bolts are torqued to 120 ft-lbs
___ Motor Bolts are torqued to 120 ft-lbs
___ Belt Alignment& tension adjustment is correct.
___ Cutter shaft bearings are properly lubricated
___ Roller bearings are properly lubricated
___ Blades swing freely.
___ All Pins and Clips for Rear Mower are installed
___ Clutch on Rear Mower has been checked for proper adjustment and conditions per
parts book reguirments.
___ All Belt guards are installed correctly.