Filter
Top Products
© 2004 Alamo Group Inc.
Page 5 - 3
Interstater (NH TS-100A , 115A , 125A & 135A Asy. Manual) 06/04
Figure 6
Exhaust Muffler
moved inward
8-1/2" from
stock location
Modify Exhaust on Tractor:
(continued)
6. Install Exhaust Mount Bracket. The new
Exhaust mounting Bracket Weldment (See
Figure 4 & 5 P/N 02980649) must be installed to
mount the new Turbo Downpipe to using the 3-1/
2" Clamp (P/N 02959132) to mount the Downpipe
the new Exhaust mounting bracket. Note: The
New Exhaust Bracket has slotted holes in it that
are not shown in the angle that figure 4 is showing
the weldment. There are 3 Bolts and lockwashers
used to mount this weldment.
7. Reinstall Muffler. Reinstall the muffler
using the existing hardware for the muffler. Turn
the tip of the muffler toward the LH side of tractor
as shown in Figure 6 if it is not already. Muffler
should now be 8-1/2" inward from the stock loca-
tion, this is a must for clearance of the Wing when
folded in the up ( Transport) position. Note figure
6 show a high frame installed, this is for reference
only, the muffler should be modified before frame
and boom are mounted.
8. Muffler Clearance. Make certain that the
hoses, wiring and other components are not touch-
ing the muffler. Make certain that all shields if any
are replaced around muffler and exhaust pipe.
9. The LH Outside Rear View Mirror. The Left
Hand outside rear view mirror will have to be
removed as the boom will not clear it mounted to
the cab. Any lights and/or brackets bolted to the
hand rail on the RH side of the cab will have to be
moved for clearance or remove completely. This
will be determined by the installer at the time of
installation.
Figure 4
New
Exhaust
Mntg Brkt
at corner
of Cab
Figure 5
New
Exhaust
Mntg Brkt
at corner
of Cab
Tractor Exhaust Modification