Filter
Top Products
© 2004 Alamo Group Inc.
Page 6 - 2
Interstater (NH TS-100A , 115A , 125A & 135A Asy. Manual) 06/04
Tractor Fuel Tank Replacement:
1. Remove the New Holland Factory Fuel
Tank From Tractor. Drain all the fuel from the fuel
tank with an approved pump or other device. Store
fuel in an approved area. Remove the factory fuel
tank. It is somewhat easier if the left rear tire &
wheel are removed but it is not required. Some
Tractors come with an optional Fuel Tank Protec-
tion Plate under tank, if you have this plate it will not
be used with the Alamo Industrial replacement
tank. (See Figure 1).
2. Remove the fuel sending unit from the
factory tank. The factory fuel sending unit for the
fuel level gauge will be reused, it will bolt into the
replacement tank with out any modifications (See
Figure 3). Note the replacement tank will come to
you all ready painted but it may require touching up
after mounting.
3. Install New Fuel Tank. The replacement
fuel tank will install with the new straps supplied
from Alamo Industrial. The is a Step Weldment
that will bolt to the fuel tank to tank the place of the
factory step that had to be removed.
Manufactured Fuel Tank Installation
Figure 1
New Holland
Factory Fuel
Tank
Figure 2
Tire & Wheel Moved
For Illustration
Tank unpainted For
Illustration only
Figure 3
Factory Fuel Gauge
Sending Unit
Figure 4