Filter
Top Products
© 2004 Alamo Group Inc.
Page 4 - 2
Interstater (NH TS-100A , 115A , 125A & 135A Asy. Manual) 06/04
Remote Control Cable Connections
1. Control Valve Cable Clips. Locate the four
cable mounting clips and four roll pins (shown laying
on muffler bracket for illustration only in Figure 1).
Start the roll pins into the clips as shown through one
side only (See Figure 1). Insert the Remote Cable
through the Control Valve Mount Bracket (See Fig-
ure 2). Install the large cable retaining / Adjusting nut
onto threaded portion of cable housing (See Figure
2). DO NOT tighten this large nut until later. On the
tip of the threaded end of the cable there is a 1/4" nut.
Screw this nut down onto cable. Insert the cable clip
down over threaded cable end (See Figure 3). Find
the four 1/4" nut supplied, install one onto end of
cable down into clip. This nut should be screwed
onto cable at least the thickness of the nut, do not
screw it on so far that it will interfere with the
operation of the cable. Using the nut that was already
on the cable screw the nut out until it is against the
clip from the bottom side, tightening this nut against
clip will lock the other nut inside of clip. (See Figure
3).
2. Connect Clip to Valve Spool. Turn the clip
and the valve spool to where the hole in the clip and
the hole in the clip are aligned. Using a hammer drive
the roll pin through the hole in the spool and through
the other side of clip (See Figure 4) . Make certain to
keep the clip aligned when driving pin in. Turn the clip
and spool as shown (See Figure 5), Continue this
with the other 4 cables and clips (See Figure 6).
3. Connect Cylinder Hoses to Valve. There are
six cylinder hoses that connect to Control Valve.
One Pressure "P" hose and one Tank "T" hose.
These hoses are connected as follows (See Figure
7 , 9 & 23)
1. Tilt Cyl. Rod End RH Wing.
2. Tilt Cyl, Butt End RH Wing.
3. Lift Cyl. Rod End, RH Wing.
4. Tilt Cyl. Rod End LH Wing.
5. Tilt Cyl. Butt End LH Wing.
6. Lift Cyl. Rod End LH Wing.
7. "P" Pressure Hose from Pump
8. "T" Return Hose To Tank
Connect hoses with elbow pointing down (See Fig-
ure 8)
Cable Mounting Clips &
Roll Pins (Qty 4 ea.)
Figure 1
Figure 2
Figure 3
Screw this
small nut down
onto cable
Remote Control Cable Connections Cab Tractor: