Filter
Top Products
Manual Updates
The following updates have been made to this manual since its publication.
7/22/99
Additional information about CV mode operation has been added to pages 25 and 26.
The sampling rate for output 2 has been corrected on pages 106 and 109.
The option number referred to under Output Type has been corrected on page 116.
1/7/00
All references to HP have been changed to Agilent.
All references to HP-IB have been changed to GPIB.
Information about Output Coupling has been added to pages 18, 19, 20, 54, 56 and 96.
A note about magnetic fields has been added to page 31.
Information about installing instrument drivers has been updated on page 64.
The Output command has been updated on page 114.
The INSTrument:COUPle:OUTPut:STATe command has been added to page 114.
3/10/00
H2 mode has been added to the OUTput:TYPE command on pages 19, 20, 37, 38, 54, 57, 97, and 116.
Option 521 has been added to table 2-1 on page 22.
Note 3 has been added to the specifications table on page 143.
Step 6 has been added to the DVM Measurement Accuracy procedure on page 151.
The Negative Voltage measurement values have been corrected on pages 152 and 153.
A note has been added to page 156.
Error -114 has been added to page 161.
6/30/00
Information about Option 521 has been added to page 27.
Information about load regulation and voltage drop in the remote sense leads has been added to page 35.
The OUTPut[1 | 2]:RELay:MODE command has been added to pages 19, 20, 54, 58, 97, and 114.
The definition of the Transient Response specification on page 143 has been updated.
Minor corrections have been made to the Programming Resolution, Voltage Rise Time, and Voltage
Settling Time characteristics on page 144.
Table A-4 has been added to Appendix A.