Filter
Top Products
8 – Language Dictionary
122
Table 8-4. Bit Configuration of Operation Status Registers
Bit Position
15–13 12 11 10 9 8 7-6 5 4-1 0
Bit Name
not
used
CC2 CC- CC+ CV2 CV not
used
WTG not
used
CAL
Bit Weight
4096 2048 1024 512 256 32 1
CAL = The dc source is computing new calibration constants.
WTG = The dc source is waiting for a trigger.
CV = The dc source is operating in constant voltage mode.
CV2 = Output 2 is operating in constant voltage mode. (Agilent 66309B/D only)
CC+ = The dc source is operating in constant current mode.
CC- = The dc source is operating in negative constant current mode.
CC2 = Output 2 is operating in constant current mode. (Agilent 66309B/D only)
STATus:OPERation?
This query returns the value of the Operation Event register. The Event register is a read-only register,
which holds (latches) all events that are passed by the Operation NTR and/or PTR filter. Reading the
Operation Event register clears it.
Query Syntax
STATus:OPERtion[:EVENt]?
Parameters
None
Returned Parameters
<NR1>(Register Value)
Examples
STAT:OPER?
Related Commands
*CLS STAT:OPER:NTR STAT:OPER:PTR
STATus:OPERation:CONDition?
This query returns the value of the Operation Condition register. That is a read-only register, which holds
the real-time (unlatched) operational status of the dc source.
Query Syntax
STATus:OPERation:CONDition?
Parameters
None
Examples
STAT:OPER:COND? STATUS:OPERATION:CONDITION?
Returned Parameters
<NR1> (register value)
STATus:OPERation:ENABle
This command and its query set and read the value of the Operational Enable register. This register is a
mask for enabling specific bits from the Operation Event register to set the operation summary bit
(OPER) of the Status Byte register. This bit (bit 7) is the logical OR of all the Operatonal Event register
bits that are enabled by the Status Operation Enable register.
Command Syntax
STATus:OPERation:ENABle<NRf>
Parameters
0 to 32767
Preset Value
0
Examples
STAT:OPER:ENAB 1312
Query Syntax
STATus:OPERation:ENABle?
Returned Parameters
<NR1> (register value)
Related Commands
STAT:OPER:EVEN