C2630M-B (4/08) 59
CONFIGURING PRESET TOURS
A preset tour allows a camera to move through a programmed sequence of PTZ presets. The DX8100 Series DVR can store up to four preset
tours. While four tours can be programmed, only one tour can be activated at a time. A preset tour will operate continuously until another PTZ
control action is performed. At least one PTZ preset must be set in order to create a preset tour.
The PTZ controls are hidden in the extended view mode. In this case, select the standard view mode to display the PTZ controls.
To switch between the standard and extended view mode:
• From the DX8100 menu bar, choose View > Extended View.
This section describes how to configure preset tours and includes the following topics:
• Programming a Preset Tour
• Activating a Preset Tour on page 62
• Deactivating a Preset Tour on page 62
PROGRAMMING A PRESET TOUR
This section describes how to program a preset tour and includes the following topics:
• Accessing a Preset Tour Group
• Adding Presets to a Tour on page 60
• Deleting Presets from a Tour on page 61
Accessing a Preset Tour Group
To access the “Preset tour group” dialog box:
1. On the DX8100 toolbar, click .
2. On the DX8100 keypad, click and then on the PTZ keypad. The “Preset tour group” dialog box opens.
3. Select the preset tour (1-4) that you want to program from the drop-down box.
4. Do one of the following:
• To add presets to a tour, refer to Adding Presets to a Tour on page 60.
• To delete presets from a tour, refer to Deleting Presets from a Tour on page 61.
Figure 34. Preset Tour Dialog Box
ᕣ
