Connecting the Components
4-76800-A2-GN22-30 January 1997
87654321
PORT
PORT OK
RECEIVE
ACTIVITY COLLISION POWER
Allied Telesis
CentreCOM™
MR810T
IEEE 802.3 10 BASE T
8 PORT MICRO REPEATER WITH AUI
Allied Telesis
CentreCOM™
MR810T
IEEE 802.3 10 BASE T
MICRO REPEATER WITH AUI
8
x
7
x
6
x
5
x
4
x
3
x
2
x
1
x
493-14257
Figure 4-4. Network Hub Unit
Once you have this equipment assembled, perform the following steps:
1. Connect the network hub unit power cord to a non-switched outlet.
2. Connect the AUI adapter to the Ethernet card on the host processor.
3. Connect one end of a 035-0116-5031 cable to the AUI adapter.
4. Connect the other end of a 035-0116-5031 cable to a port on the network hub unit.
5. Connect one end of a 035-0116-5031 cable to the jack on the EtherLink II card in the
full-feature workstation.
6. Connect the other end of the 035-0116-5031 cable to a port on the network hub unit.
NOTE
To ensure that the TCP/IP network operates efficiently, always use
the shortest cord possible to connect each device to the network
hub unit.
