DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-406status card-mem
8
Status The possible values for the "Status" field are:
"inserted"a valid memory card is in the memory card slot
"no card"no memory card is inserted or the inserted memory card
has a bad connection
"unformatted"the inserted memory card is unformatted or can not
be recognized by the switch
Only when the status is "inserted," the switch can perform I/O
operation to the memory card
Write-Protection The "Write-Protection" field has a value "on" when the write-protection
toggle on the memory card is turned on. Otherwise, the field is "off."
If the "Write-Protection" field is "on," then the switch can not store any
file to the memory card.
Number of Erase
Pulses
This field contains the number of pulses counted in the last erase
operation on a Series 1 type of memory card. This field is blank for
Series 2 type of memory card due to the different algorithm of erase
operation between two series.
Translation
Storage Space
Used (%)
Indicates the percentage of reserved storage space for storing
translation file in the memory card that has been used for saving the
translation into the memory card.
NOTE:
This percentage is valid only for the specific memory card
used in the
most recent
save translation operation (which is
implemented via the save translation command or via the
scheduled maintenance with save translation enabled). If the
memory card is replaced with another card, or if no save
translation is performed on the new memory card, the
percentage does not indicate the translation storage space
used in the new card. Therefore, in such a case, the
percentage can be ignored.
File Name Each formatted memory card has reserved a fixed space in the card
for each file. The starting address and size of each reserved slot is
pre-determined according to the capacity of the memory card. The
file name as defined in Table "Capacity of Memory Card" is shown in
this field.
Data Present The "Data Present" field is "y" when the file contains valid data.
Otherwise, the "Data Present" field has a value of "n."
Date Time This field shows the date and time when the file was saved into the
memory card. For the "Software Upgrade" type of memory card, this
field contains the system software release number instead of the
time stamp. Due to the restriction of "core dump" file format, the year
information is not available in the date/time string.
